Using Probe Manager With Your Digitizer - About Using a Dynamic Reference Frame with 3DCreator Probes - Disabling a 3DCreator Dynamic Reference Frame

Disabling a 3DCreator Dynamic Reference Frame

DRFs are associated with probe definitions for 3DCreator digitizers. In order to stop using a DRF when digitizing you must deselect the DRF option for the probe currently in use and for any other probe you intend to use.

When you turn off the use of a DRF with a probe, the coordinate system used reverts to the internal coordinate system of the 3DCreator camera array. Without the benefit of a DRF, the coordinate system floats with the camera if it is moved. Avoiding the use of a DRF may improve the accuracy of your measurements, but at the cost of losing the ability to freely move the camera in relation to the part being digitized.

To Disable a 3DCreator DRF

View the probe currently in use with which the DRF is associated.
Deselect Use DRF.

Related Articles
Using Probe Manager With Your Digitizer - About Using a Dynamic Reference Frame with 3DCreator Probes
About Using a Dynamic Reference Frame with 3DCreator Probes 3DCreator devices support the use of a Dynamic Reference Frame when capturing data. A DRF is an auxiliary piece of hardware with a configuration of infrared emitters, similar to a probe. ...
Using Probe Manager With Your Digitizer - About Using a Dynamic Reference Frame with 3DCreator Probes - Using a Dynamic Reference Frame with a 3DCreator Probe
Using a Dynamic Reference Frame with a 3DCreator Probe DRFs are associated with specific probes within the Probe Manager. You may use a single DRF with multiple probes. In order to use a DRF with a probe, you must add identifying information to the ...
Disabling Probe Manager
Disabling Probe Manager You can choose whether or not to use Probe Manager for each digitizing session. When you disable Probe Manager, RevWorks treats your digitizer as a single probe device and collects data as if a point probe is in use. To ...
Using Probe Manager With Your Digitizer - Using Probe Manager with 3DCreator Digitizers
Using Probe Manager with 3DCreator Digitizers The Probe Manager interface for 3DCreator digitizers automatically presents one partially defined probe for your use. 3DCreators may ship with one or more probe, each having unique factory calibrations. ...
Using Probes - Qualifying the Reference Probe
Qualifying the Reference Probe Some digitizing devices require that a reference probe be designated to qualify other probes against. Typically this applies to devices that use probes with indexable probe heads such as bridge CMMs. When working with ...

Using Probe Manager With Your Digitizer - About Using a Dynamic Reference Frame with 3DCreator Probes - Disabling a 3DCreator Dynamic Reference Frame

Using Probe Manager With Your Digitizer - About Using a Dynamic Reference Frame with 3DCreator Probes - Disabling a 3DCreator Dynamic Reference Frame

Related Articles

Using Probe Manager With Your Digitizer - About Using a Dynamic Reference Frame with 3DCreator Probes

Using Probe Manager With Your Digitizer - About Using a Dynamic Reference Frame with 3DCreator Probes - Using a Dynamic Reference Frame with a 3DCreator Probe

Disabling Probe Manager

Using Probe Manager With Your Digitizer - Using Probe Manager with 3DCreator Digitizers

Using Probes - Qualifying the Reference Probe