Creating Surfaces - Creating an Axis-Aligned Surface
Creating an Axis-Aligned Surface
RevWorks creates an axis-aligned surface from a set of digitized 3D points. The axis-aligned surfaces are square surface patches with edges aligned to an axis of the SOLIDWORKS model space. These surfaces are smooth, best-fit surfaces over the set of collected data. RevWorks does not compensate surfaces or 3D points even if probe compensation is activated.
To Create an Axis-Aligned Surface
-
Select an existing plane that approximates the orientation of the surface patch being digitized.
Note: If you do not pre-select a plane DirectSurf attempts to determine the best plane from the actual data collected. This can produce unexpected results if the data you collect is weighted towards one side of the patch rather than being evenly distributed.
-
From the RevWorks toolbar, select
,
or from the RevWorks toolbar right click on any displayed Surface icon and choose Axis Aligned,
or select Surface > Axis Aligned from the RevWorks menu in SOLIDWORKS.
RevWorks will open a 3D sketch for the points and prompts you to begin digitizing points.
|
|
Note: RevWorks allows you to utilize single point or scan point data collection modes to capture surface data. |
-
Digitize a well-distributed set of points over the entire surface you would like to capture.
Note: The digitized 3D points are shown as they are captured in the SOLIDWORKS 3D sketch.
-
Once you have collected the surface points, select
or another completion option to calculate the feature.
RevWorks generates a square axis-aligned surface from the collected data and places it into the SOLIDWORKS model space.
Related Articles
Creating Surfaces - Creating a Point-Aligned Surface
Creating a Point-Aligned Surface RevWorks creates a point-aligned surface from a set of digitized 3D points. The point -aligned surfaces are square surface patches aligned to the vector created from the first two digitized points. These surfaces ...Creating Surfaces
Creating Surfaces RevWorks creates surfaces that are added to the SOLIDWORKS feature tree as independent items. The surfaces are seen by SOLIDWORKS as imported surface definitions. With RevWorks you can also create parametric surfaces. The surfaces ...Creating Parametric Surfaces in RevWorks
Creating Parametric Surfaces RevWorks can automatically generate a parametric surface from collected point data. When Parametric Surface generation is enabled, RevWorks automatically creates a series of sketch profiles that are used as lofting and ...Creating Surfaces - Creating a Spline-Bounded Surface
Creating a Spline-Bounded Surface RevWorks creates a spline-bounded surface from a set of digitized 3D points. The spline-bounded surfaces are surface patches whose outside edge is defined by a spline of a specified degree of tightness. These ...About Parametric Surfaces - Creating Parametric Surfaces
Creating Parametric Surfaces RevWorks can automatically generate a parametric surface from collected point data. When Parametric Surface generation is enabled, RevWorks automatically creates a series of sketch profiles that are used as lofting and ...