Using CADpad in RevWorks
About CADpad
About CADpad This feature provides an alternative interface for users to the software using the MicroScribe via a Grid of buttons or Mouse input. The grid creates an area of input where the buttons on the hand switch (or foot pedal) cause the launch ...
CADpad Mouse
CADpad Mouse The CADpad Mouse allows a digitizer to emulate the mouse. The defined area, scales to correct aspect ratio, will act as an absolute positioning device when the digitizer probe is in that area. Buttons on the digitizer will act as mouse ...
CADpad Grid
CADpad Grid The CADpad grid allows for defining a surface for input from a digitizer to "drive" an application. Clicks in this defined area can result in RevWorks "messages" (that emulate the click of any of the buttons on the RevWorks toolbar); ...
Aligning a CADpad
Aligning a CADpad The first time you use either CADpad feature, you must align your template area: Right click on the icon then select Align Grid or Align Mouse. The Alignment dialog will be displayed. Set the corner locations for your selected Grid ...