About Gage 2000a Digitizers

About Gage 2000a Digitizers

About Gage 2000a Digitizers

 

Gage 2000a digitizers are rugged, articulated portable measurement arms. The complete Gage 2000a product line features several models ranging in size, accuracy, and freedom-of-movement configurations. Gage 2000a arms support probe exchange, allowing as many as four distinct probes to be used without requiring recalibration. In order to use a Gage 2000a digitizer with RevWorks, you must perform the following procedures:

  1. Choosing Digitizers
  1. Connecting Connecting Gage 2000a Digitizers
  1. Configuring RevWorks for Gage 2000a Digitizers
  1. Starting Gage 2000a Digitizers
  1. Using Probe Manager with Gage 2000a Digitizers

 

Gage 2000a arm digitizers maintain a user-adjustable coordinate system within its internal registers. By using the Calip3D software that comes with all Gage 2000a digitizers, you can modify the coordinate system for your Gage 2000a digitizer. In addition, you can use the Calip3D software to calibrate any probe you plan to use with the Gage 2000a device. Once calibrated, a probe may be used and interchanged with other calibrated probes. The Calip3D software provides other features, including some useful diagnostic tools.

RevWorks communicates with Gage 2000a arm digitizers using a serial device interface. Please refer to the Gage 2000a operation manuals for specific information on the care and upkeep of your device.



    • Related Articles

    • Starting - Starting Gage 2000a Digitizers

      Starting Gage 2000a Digitizers   Gage 2000a digitizers do not require any special setup before starting. To Start a Gage 2000a Digitizer Make sure that the device is securely mounted to the working surface or tripod. Note: See your Gage 2000a ...

    • Connecting - Connecting Gage 2000a Digitizers

      Connecting Gage 2000a Digitizers   RevWorks is completely compatible with Gage 2000a articulated arm digitizers. Before connecting a Gage 2000a digitizer, the device must be properly secured for use. For specific instructions on how to properly mount ...

    • Starting - Starting 3DCreator Digitizers

      Starting 3DCreator Digitizers   When starting 3DCreator digitizers you must first make sure that the components to be used are properly connected, the article to be digitized is placed within the working area of the camera sensor array, and that the ...

    • Starting - Starting FARO USB Digitizers

      Starting FARO USB Digitizers   FARO USB portable CMMs do not require any special setup before starting. Once communication is first attempted an arm start-up calibration dialog is presented that displays a generic image of an arm and red arrows ...

    • Connecting - Connecting Romer Digitizers

      Connecting Romer Digitizers   RevWorks is completely compatible with the entire family of Romer articulated arm digitizers. Before connecting a Romer digitizer, the device must be properly secured for use. There are a variety of mechanisms available ...