The CADpad Mouse
allows a digitizer to emulate the mouse. The defined area, scales to correct
aspect ratio, will act as an absolute positioning device when the digitizer
probe is in that area. Buttons on the digitizer will act as mouse buttons.
About CADpad This feature provides an alternative interface for users to the software using the MicroScribe via a Grid of buttons or Mouse input. The grid creates an area of input where the buttons on the hand switch (or foot pedal) cause the launch ...
CADpad Grid The CADpad grid allows for defining a surface for input from a digitizer to "drive" an application. Clicks in this defined area can result in RevWorks "messages" (that emulate the click of any of the buttons on the RevWorks toolbar); ...
Aligning a CADpad The first time you use either CADpad feature, you must align your template area: Right click on the icon then select Align Grid or Align Mouse. The Alignment dialog will be displayed. Set the corner locations for your selected Grid ...
Disabling Probe Manager You can choose whether or not to use Probe Manager for each digitizing session. When you disable Probe Manager, RevWorks treats your digitizer as a single probe device and collects data as if a point probe is in use. To ...
Accessing Probe Manager Probe Manager is presented as a drop-down window from the RevWorks toolbar. To Toggle the Display Probe Manager Left click on the RevWorks toolbar, or From the RevWorks menu in SOLIDWORKS, select Probe Manager > Display. ...