Aligning a CADpad

Aligning a CADpad

Aligning a CADpad

The first time you use either CADpad feature, you must align your template area:

Right click on the icon then select Align Grid or Align Mouse.

The Alignment dialog will be displayed.

Set the corner locations for your selected Grid template (1,2,3) or Mouse active area by touching the corners of the desired CADpad area on your desk or other surface with MicroScribe stylus and clicking the trigger button at each location.

When finished, click OK.

    • Related Articles

    • CADpad Grid

      CADpad Grid The CADpad grid allows for defining a surface for input from a digitizer to "drive" an application.  Clicks in this defined area can result in RevWorks "messages" (that emulate the click of any of the buttons on the RevWorks toolbar); ...

    • About CADpad

      About CADpad This feature provides an alternative interface for users to the software using the MicroScribe via a Grid of buttons or Mouse input. The grid creates an area of input where the buttons on the hand switch (or foot pedal) cause the launch ...

    • CADpad Mouse

      CADpad Mouse The CADpad Mouse allows a digitizer to emulate the mouse.  The defined area, scales to correct aspect ratio, will act as an absolute positioning device when the digitizer probe is in that area.  Buttons on the digitizer will act as mouse ...

    • About Troubleshooting RevWorks

      About Troubleshooting RevWorks   If you are having trouble with a RevWorks feature or option, review the following topics before contacting your RevWorks reseller or Revware for support. I cannot see the RevWorks toolbar upon starting SOLIDWORKS. ...

    • Configuring - Configuring RevWorks for FARO USB Digitizers

      Configuring RevWorks for FARO USB Digitizers   FARO USB digitizers require no hardware configuration for use. When RevWorks first attempts to communicate with a FARO USB device, RevWorks automatically initializes the communications parameters to ...