Starting - Starting Digitizers

Starting - Starting Digitizers

Starting Digitizers

 

Digitizers have different startup procedures. Remember, when you first attempt to collect data, you may notice a delay time in processing speed. That is because RevWorks executes a connection procedure that secures data communications with your digitizing device. Depending on the type of digitizing device you are using, the connection procedure may take several seconds before processing speed returns to normal.

Refer to your digitizer’s user manual for specific information on the setup, use, and care of your digitizing device.

  1. Starting MicroScribe Digitizers
  1. Starting Romer Digitizers
  1. Starting 3DCreator Digitizers
  1. Starting FARO USB Digitizers
  1. Starting FARO Serial Digitizers
  1. Starting Gage 2000a Digitizers

    • Related Articles

    • Starting - Starting FARO USB Digitizers

      Starting FARO USB Digitizers   FARO USB portable CMMs do not require any special setup before starting. Once communication is first attempted an arm start-up calibration dialog is presented that displays a generic image of an arm and red arrows ...

    • Starting - Starting Romer Digitizers

      Starting Romer Digitizers   Romer portable CMMs do not require any special setup before starting. Once communication is first attempted an arm start-up calibration dialog is presented that displays a set of progress bars indicating which arm joints ...

    • Starting - Starting FARO Serial Digitizers

      Starting FARO Serial Digitizers   FARO digitizers do not require any special setup before starting. To Start a FARO Serial Interface Digitizer Make sure that the device is securely mounted to the working surface or apparatus and that it is properly ...

    • Connecting - Connecting Digitizers

      Connecting Digitizers   Before you can use a digitizing device with RevWorks, you must install RevWorks, install any software device drivers required by your digitizing device and connect the device to your computer. If you have a digitizer that uses ...

    • Starting - Starting Gage 2000a Digitizers

      Starting Gage 2000a Digitizers   Gage 2000a digitizers do not require any special setup before starting. To Start a Gage 2000a Digitizer Make sure that the device is securely mounted to the working surface or tripod. Note: See your Gage 2000a ...