Feature Preferences - Setting Minimum Corner Distance for Rectangle Creation

Setting Minimum Corner Distance for Rectangle Creation

 

When generating a rectangle of more than two points, you can specify the distance that any two successive points must be apart before a corner may split them.

Note: RevWorks displays measurements in the same units as the currently active part or assembly document. You can enter values in any other supported unit of measure by adding the recognized abbreviation after the value you enter.

To Set the Rectangle Cornering Distance

1. From the RevWorks toolbar, select ,
   or select Options… from the RevWorks menu.

The Options dialog appears.

2. In the Features tab, select the Rectangle feature type from the Property Tree to access its property options.

3. Enter a value for Minimum Corner Distance.

• Related Articles

• Feature Preferences - Setting Continuous Data Collection Mode

  Setting Continuous Data Collection Mode   If you have a lot of data to collect and many of the same features to create, you can set continuous data collection. This allows you to sequentially digitize any number of features of the same type in ...

• Feature Preferences - Setting Minimum Spline Node Separation for Sketch Splines

  Setting Minimum Spline Node Separation for Sketch Splines   This procedure only applies if you are collecting data in scan point mode. If you are collecting data in single point mode, this procedure does not apply to you. If you plan to work with ...

• Feature Preferences - Setting Unlimited Data Collection Mode

  Setting Unlimited Data Collection Mode   If you wish to collect the same feature type using a variety of point samples, you have the option of turning off data collection limits. This option allows you to collect any number of points above the ...

• Feature Preferences - About Feature Preferences

  About Feature Preferences   RevWorks provides several options for configuring data collection and feature characteristics. By adjusting these settings you can fine tune feature creation to better meet the needs of your particular work environment.   ...

• Feature Preferences - Limiting the Number of Points for Features

  Limiting the Number of Points for Features   By limiting the number of points for features, you set RevWorks to automatically calculate and create a feature upon collecting the number of points required for the feature. Limiting the number of points ...