Device Preferences - About Device Preferences

Device Preferences - About Device Preferences

About Device Preferences

 

RevWorks supports several types of digitizing devices from a variety of manufacturers. Each specific device has its own configuration options and requirements. To work with a specific device, you must identify the device you wish to work with and then choose the appropriate options to communicate with it successfully.

Each supported digitizing device has an associated Options page which is displayed within the Options Dialog when the device is chosen as the active device. Additionally, some devices also have an accompanying Tools page which is displayed when the associated devices are chosen.

Digitizer Choices

  1. Choosing Digitizers

Options Property

  1. Configuring RevWorks to Work With Digitizers

    • Related Articles

    • Device Preferences - Choosing Digitizers

      Choosing Digitizers   Because RevWorks supports multiple digitizers, you must specify which digitizer you plan to use. When you initially installed RevWorks, you chose the devices you wish to use from a list of supported digitizers. All of those ...

    • Configuring - Configuring RevWorks for MicrScribe Digitizers

      Configuring RevWorks for MicroScribe Digitizers   The MicroScribe digitizer requires no hardware configuration in order to use. However, for 3D series arms you must make sure that the machine is in its proper "home" position before turning it on. ...

    • About MicroScribe Digitizers

      About MicroScribe Digitizers   MicroScribe digitizers are compact, articulated desktop measurement arms. There are four series of MicroScribe arms: the older 3D series that communicates via a serial interface only; the G and i series that ...

    • Configuring - Configuring RevWorks to Work With Digitizers

      Configuring RevWorks to Work With Digitizers   RevWorks requires configuration options for each digitizing device that you use. At any time, you can change configuration options for digitizers and RevWorks communication parameters. All changes take ...

    • Configuring - Configuring RevWorks for 3DCreator Digitizers

      Configuring RevWorks for 3DCreator Digitizers   The 3DCreator may require some hardware configuration before first use in order to properly identify the probes and Dynamic Reference Frames that are to be used. The actual configuration of RevWorks for ...