RevWorks provides several options for configuring data collection and
feature characteristics. By adjusting these settings you can fine tune feature
creation to better meet the needs of your particular work
environment.
Setting Automatic Sorting of Points for Sketch Splines If you plan to work with 2D splines, you can set RevWorks to automatically sort data before creating 2D splines in single point or scan point mode. By sorting spline data before creating 2D ...
Setting Continuous Data Collection Mode If you have a lot of data to collect and many of the same features to create, you can set continuous data collection. This allows you to sequentially digitize any number of features of the same type in ...
Setting Unlimited Data Collection Mode If you wish to collect the same feature type using a variety of point samples, you have the option of turning off data collection limits. This option allows you to collect any number of points above the ...
Setting Automatic Plane Alignment If you plan to work with planes, you can set RevWorks to automatically align new planes with SOLIDWORKS default planes. Automatic plane alignment affects the alignment of sketch coordinates within the plane to the ...
Limiting the Number of Points for Features By limiting the number of points for features, you set RevWorks to automatically calculate and create a feature upon collecting the number of points required for the feature. Limiting the number of points ...