About Surfaces - Setting Surface Extension

About Surfaces - Setting Surface Extension

Setting Surface Extension

 

Often when collecting data to form a surface to be used as an extrusion boundary or as a cutting surface, it is not possible to get points close enough to the edge of the surface to fully bound or cut the solid being created. To remedy this, RevWorks allows you to extend the digitized surface by a percentage of its over all size using the same algorithm utilized in the creation of the surface. This allows the user to digitize the surface as it actually exists and extend the digitized edges so that the surface may be used by the CAD system to create the desired geometry.

In order to set the surface extension, you must enable the extend surface and then enter a value representing the percentage increase in the size of the digitized surface. This will extend all sides of the surface by that percentage.

At any time, you can disable, or enable and set the surface extension by performing the following procedures.

To Disable, or Enable and Set Surface Extension.

  1. From the RevWorks toolbar, select ,
    or select     Options… from the RevWorks menu.

The Options dialog appears.

  1. In the Surface tab, select/deselect Extend Surface.

  2. Type in a % Extension value. The default value is 5% and valid values are from 0-25%.

    • Related Articles

    • DirectSurf Preferences - Setting Surface Extension

      Setting Surface Extension   Often when collecting data to form a surface to be used as an extrusion boundary or as a cutting surface, it is not possible to get points close enough to the edge of the surface to fully bound or cut the solid being ...

    • About Surfaces - Setting Surface Type

      Setting Surface Type   RevWorks can automatically generate two types of surfaces from collected point data: Curved (NURBS) - Creates a smooth, best-fit surface feature that approximates the curvature of the collected data. Planar – Creates a best-fit ...

    • About Parametric Surfaces - Enabling Parametric Surface Generation

      Enabling Parametric Surface Generation   RevWorks can generate static reference surfaces or parametric surfaces. When the generation of parametric surface has been enabled, RevWorks automatically creates the set of section planes and sketch profiles ...

    • About Parametric Surfaces - Setting the Number of Profiles for Parametric Surface Generation

      Setting the Number of Profiles for Parametric Surface Generation   You can set the number of profiles that RevWorks creates to generate a parametric surface. To Set the Number of Profiles Used for Parametric Surface Generation. From the RevWorks ...

    • About Surfaces - Setting Spline Type for Spline-Bounded Surface

      Setting Spline Type for Spline-Bounded Surface   The limits of Spline-Bounded surfaces are defined by a single spline that you control with the Spline Boundary Type option setting. The setting you choose determines how closely the trimming spline ...