Creating Points

• Related Articles

• Creating Points - Creating a Sketch Point at the Intersection of Two Lines

  Creating a Sketch Point at the Intersection of Two Lines   RevWorks creates a line-derived point by calculating the intersection of two digitized lines. The points collected for the lines are projected to the active sketch plane before each line is ...

• Creating Points - Creating a Sketch Point at the Intersection of Three Planes

  Creating a Sketch Point at the Intersection of Three Planes   RevWorks creates a plane-derived point by calculating the intersection of three individually digitized planes. None of the three planes used can be parallel. The resulting point feature is ...

• Creating Lines - Creating a Sketch Line Using Two Planes

  Creating a Sketch Line Using Two Planes   RevWorks constructs a plane-derived line by calculating the intersection of two individually digitized planes. The two planes used must not be parallel. The resulting line feature is projected to the active ...

• Creating Points - Creating a 3D Point at the Intersection of Three Planes

  Creating a 3D Point at the Intersection of Three Planes   RevWorks creates a plane-derived point by calculating the intersection of three individually digitized planes. None of the three planes used can be parallel. The resulting point feature is ...

• Creating Points - Creating a Sketch Point at the Center of a Circle

  Creating a Sketch Point at the Center of a Circle   RevWorks creates a circle-derived point at the center of a digitized circle. The points collected for the circle are projected to the active sketch plane before the circle is calculated. The center ...