Creating Points - Creating a Sketch Point at a Location
Creating a Sketch Point at a Location
RevWorks creates point features from a single digitized point. RevWorks does not compensate points even if probe compensation is activated. 2D sketch points are always projected to the active sketch plane no matter how far away from the plane they were collected.
To Create a Sketch Point
-
From the RevWorks toolbar, select
,
or from the RevWorks toolbar right click on any displayed Point icon and choose Sketch Point > Points,
or select Point > Sketch Point > Points from the RevWorks menu in SOLIDWORKS.
RevWorks prompts you to digitize a point.
-
Digitize a location of the point on the part.
RevWorks automatically generates a point feature from the collected data and draws it on the active SOLIDWORKS sketch plane.
Related Articles
Creating Points - Creating a 3D Point at a Location
Creating a 3D Point at a Location RevWorks creates 3D point features from a single digitized point. RevWorks does not compensate points or 3D geometry even if probe compensation is activated. To Create a 3D Point From the RevWorks toolbar, select , ...Creating Points
Creating Points RevWorks provides multiple methods for creating points. Points may be created within planar 2D sketches and 3D sketches. Points can be created or constructed at the intersection or center of a variety of features that you digitize. ...Creating Points - Creating a Sketch Point at the Center of a Sphere
Creating a Sketch Point at the Center of a Sphere RevWorks creates a sphere-derived point at the center of a digitized sphere. The resulting point feature is projected to the active sketch plane. This is an important consideration since unless the ...Creating Points - Creating a Sketch Point at the Intersection of Three Planes
Creating a Sketch Point at the Intersection of Three Planes RevWorks creates a plane-derived point by calculating the intersection of three individually digitized planes. None of the three planes used can be parallel. The resulting point feature is ...Creating Points - Creating a Sketch Point at the Intersection of Two Lines
Creating a Sketch Point at the Intersection of Two Lines RevWorks creates a line-derived point by calculating the intersection of two digitized lines. The points collected for the lines are projected to the active sketch plane before each line is ...