Collecting Data for Sketch Features
Collecting Data for Sketch Features
RevWorks collects data you select for 2D features and projects the points onto the active sketch plane. Points that are collected off of the surface are projected perpendicularly to the sketch. This allows you the capability of easily capturing profile geometries, such as hole and boss sections, at the intersection with a planar surface even thought the data you collect is not actually on the edge. RevWorks computes and places the generated feature on the active sketch.
To Collect Data for a Sketch Feature
-
Open a part file, if applicable.
-
Select a SOLIDWORKS plane, sketch, or planar part surface that defines the target data collection plane.
If you select a plane or planar part surface, RevWorks creates a new sketch plane. If you select a sketch, RevWorks uses the sketch you choose.
|
|
Note: If you do not select a plane, sketch, or planar part surface to receive data, RevWorks displays a message informing you to select one before continuing. |
-
From the RevWorks toolbar, select the data collection mode you want to use:
for single point mode or
for scan point mode.
-
From the RevWorks toolbar or menu in SOLIDWORKS, select the type of 2D feature you want to create.
RevWorks prompts you to begin collecting data.
-
Pressing the spacebar on your keyboard or the primary button on your digitizer or auxiliary switch, digitize the minimum number of points required to create the feature.
RevWorks provides audio feedback for every point that you digitize and draws the point on the current sketch plane.
|
|
Note: You can customize sounds for many events, such as: collecting data, completing feature calculation, and deleting data. For more information, see Managing RevWorks Sounds. |
Related Articles
Collecting Data in Single Point Mode
Collecting Data in Single Point Mode Single point mode is the most common method for collecting data in RevWorks. While operating in single point mode, you collect data by pressing the data collection button of your device, an auxiliary switch, or ...Collecting Data for 3D Features
Collecting Data for 3D Features RevWorks collects data you select for 3D features and places the points into the active 3D sketch. Points are placed directly into the 3D sketch, as they are collected. RevWorks computes and places the generated ...Scanning Sketch Features in Scan Point Mode
Scanning Sketch Features in Scan Point Mode Scan point mode enables capture of point data within a limited distance of the active 2D sketch plane. This is also called snap scanning. It may help to think of the active sketch as a sectional plane. ...Collecting Data in Scan Point Mode
Collecting Data in Scan Point Mode The scan point mode allows you to collect data along any section of a part or freeform in 3D space. While operating in scan point mode, RevWorks collects data when the hard probe crosses the surface of the part, ...Scanning 3D Features in Scan Point Mode
Scanning 3D Features in Scan Point Mode The points that you digitize for a 3D sketch, curve, or surface are in true 3D SOLIDWORKS model space. Point data collected for 3D features is placed into a 3D sketch. When operating in 3D scan point mode, ...