Can I just use the CADpad Mouse feature?

Can I just use the CADpad Mouse feature?

Yes, under the MUS CADpad calibration popup box, you may select the Grid and Mouse option or select them by themselves by check the box next to the function.

    • Related Articles

    • What is CADpad in MUS?

      This feature provides an alternative interface for users to drive third-party software using the MicroScribe via a Grid of buttons or Mouse input. The grid creates an area of input where the buttons on the hand switch (or foot pedal) cause the launch ...

    • CADpad Startup Dialog

      CADpad Startup Dialog If there is a defined and active CADpad alignment on MUS startup, the following dialog will appear to indicate the current user options:   OK: Uses the previously stored alignment data to create the CADpad. Disable: Keeps the ...

    • How do I recalibrate my CADpad?

      To recalibrate your CADpad, select the CADpad icon, here you can align both the Grid and the Mouse by selecting the "Align" button. Next MUS will ask you to use your MicroScribe to measure the corners and your calibration will be finished.

    • What is the difference between a Master Probe and a Working Probe?

      A Master probe is the probe with which your MicroScribe arm was calibrated. It is identified by a red ring or dot on the neck of the probe. The Working probe looks just like the Master probe, but without the red ring or dot. It is intended for ...

    • Can I create a custom probe?

      Yes, the Custom Probe feature can be found by clicking on the Probe Options icon. 1. Select the Use Custom Probe option. 2. Select a probe profile to overwrite or redefine.  3. Follow the steps provided in MUS to calibrate your custom probe with the ...