Feature Preferences - Setting Automatic Sorting of Points for Sketch Splines
Setting Automatic Sorting of Points for Sketch Splines
If you plan to work with 2D splines, you can set RevWorks to automatically sort data before creating 2D splines in single point or scan point mode. By sorting spline data before creating 2D splines, RevWorks enables you to randomly collect data across sections of your part more than once without creating a self-intersecting spline.
At any time, you can enable or disable automatic sorting of points for 2D splines by performing the following procedures.
To Set Automatic Sorting of Points for Sketch Splines
-
From the RevWorks toolbar, select
,
or select Options… from the RevWorks menu.
The Options dialog appears.
-
In the Features tab, select the Spline feature type from the Property Tree to access its property options.
-
Select/deselect the Sort Points checkbox.
Related Articles
Feature Preferences - Setting Automatic Plane Alignment
Setting Automatic Plane Alignment If you plan to work with planes, you can set RevWorks to automatically align new planes with SOLIDWORKS default planes. Automatic plane alignment affects the alignment of sketch coordinates within the plane to the ...Feature Preferences - Setting Minimum Spline Node Separation for Sketch Splines
Setting Minimum Spline Node Separation for Sketch Splines This procedure only applies if you are collecting data in scan point mode. If you are collecting data in single point mode, this procedure does not apply to you. If you plan to work with ...Feature Preferences - About Feature Preferences
About Feature Preferences RevWorks provides several options for configuring data collection and feature characteristics. By adjusting these settings you can fine tune feature creation to better meet the needs of your particular work environment. ...Feature Preferences - Setting Continuous Data Collection Mode
Setting Continuous Data Collection Mode If you have a lot of data to collect and many of the same features to create, you can set continuous data collection. This allows you to sequentially digitize any number of features of the same type in ...Feature Preferences - Limiting the Number of Points for Features
Limiting the Number of Points for Features By limiting the number of points for features, you set RevWorks to automatically calculate and create a feature upon collecting the number of points required for the feature. Limiting the number of points ...